Saw a rifle builders website and noticed a number of their rifles had an adjustable cheek riser (the ones with the two bolts going through the side of the butt stock) which were an exact match to the stocks finish. Most of their stocks looked like Manners. I checked Manners site and didn't see anything. Anyone know where you can get these risers that match your stock's finish...
Adjustable Cheek Rest Riser
- Thread starter Triple BB
- Start date
Help Support Long Range Hunting Forum
- Joined
- Jan 26, 2015
- Messages
- 1,769
If its what I'm envisioning, it sounds like a Karsten's adjustable riser. It was likely installed and painted by the stockmaker or smith at assembly rather than a matching aftermarket addition. Not certain though.
This what your talking about?
This what your talking about?
lancetkenyon
Well-Known Member
Manners has their Ultralight Cheek Piece version. Slick deal for a few of their stocks.
Uses two threaded inserts in the top of the stock, and a Carbon Fiber piece that bolts down into them.
Uses two threaded inserts in the top of the stock, and a Carbon Fiber piece that bolts down into them.
- Joined
- Jan 26, 2015
- Messages
- 1,769
Does it just use spacers to adjust height?
Yep, that's it.
My stock is that same camo/carbon pattern. Wonder if Manners will sell them separately.
lancetkenyon
Well-Known Member
They do. I ordered two for some EH1 I have, and they matched pattern and sent the kits.
lancetkenyon
Well-Known Member
Yes. Super easy. And can be swapped for L or R handed shooters quickly.
Jakeweb09
Well-Known Member
Like to see some of the non manners stocks with these on em! How'd the installation go?
I put one on my jcs composites tactical, but it's shaped exactly like an eh1. Fits great.
How did the install go? I just ordered one and manners wanted me to send them my stock. I had them send me the parts for a home install, however.
I've done a few. Pretty easy to mark hole placement, drill, glue pillars in place and install the carbon cheek piece.
