7mm-300WSM, Pierce Ti, Proof, Manners EH1, HS Precision DBM

[clownbuster]

-7mm-300WSM (a 7WSM, headspaced off the 270 / 300WSM chamber for a longer neck, & the use of high-quality and plentiful Norma brass)
-Built by Straight Shot Gunsmithing (SSG) Nathan Dagley - Center, North Dakota
-Pierce Engineering Titanium Long Action
-28" Proof Carbon Fiber barrel, 1:8 twist, Sendero contour
-Manners EH1, Elite Tac Black Forest Camo, Atlas rail, LS flush cups, Devcon bedded
-HS Precision Gen II DBM
-Trigger Tech trigger set @ 1.5lbs
-SSG Titanium V-Port Vaporizer Muzzle Brake (Recoil is very light with this brake, akin to my 6.5 SAUM)
-Coated in Titanium Grey
-Two (2) 3-round HS Precision Gen II magazines
-Fired 122 rounds
-Weight: 6.7lbs loaded with four rounds, without glass
-Paypal Gift or add 3% to cover fee or USPS Money Order
-No scope, rings or bipod
-Attached target showing 6-shot group @ 200 yard zero.

$3700 SOLD shipped & insured to your lower 48 FFL
No trades

Decent 200 yard group, pulled my 6th a bit. Likes the 180gr Berger @ 2975fps, 2.399" base to ogive. Plenty of room to go more if desired; didn't hit pressure until 3210fps.

10-shot string, 8.1 SD, 23 ES

 

[clownbuster]

 

[lou400a]

Nate builds great sticks

 

[clownbuster]

The 7mm-300WSM uses the same headspace as the 300WSM and 270WSM, which is
shorter than the standard 7WSM. The benefits are a longer neck to support the
longer heavier bullets and availability of high-quality Norma brass, which the
plain 7WSM does not have. I make my cases out of 270WSM Norma. It doesn't
get any easier, simply take the 270WSM case and run it through your 270WSM Redding
Type S Full Length-Sizing Die with a 7mm expander button and a .312 neck
bushing installed. Prime the case, fill it with the preferred powder for the bullet
weight (For a 180 grain Berger I prefer H1000) then seat bullets with a 7WSM seating die.

 

[clownbuster]

PMS replied to

 

[clownbuster]

Sunday!

 

[jjmp]

Nate is Great !!! GLWS ...

 

[clownbuster]

TTT

 

[clownbuster]

TTT

 

[clownbuster]

TTT

 

[clownbuster]

TTT

 

[clownbuster]

All pms replied to, the usual low ballers dealt with accordingly. Guys, this is a full custom build by a high-quality gunsmith with verifiable OCD (the useful kind) using the best equipment a dollar can buy.

Cost was north of $5000. All your load development is done, barrel is broke-in and @ its operating velocity. It will shoot better than the operator.

Yes, I'll take 3000, but it will be in British pounds.

 

[clownbuster]

TTT

 

[PPR]

Beautiful rifle! Good luck with the sale.

Paul