kdrogers71775
Well-Known Member
Good morning everyone. Got the case out. This is the way i got it with the pictures in case anyone can use this in the future. Not too bad at all once i had the tools i needed.
Drilled and tapped for 1/4-20
What i used:
9/16 socket -1/4" drive. ( 3/8 will probably work with washer)
1/4-20 hex bolt. roughly 2" long.
Large 3/4" nut.
Pulled out pretty easily.
I did pour some PB Blaster on it as well. Not sure how much actually penetrated.
I'll send the rest of the pictures if all dont download in this batch.
Drilled and tapped for 1/4-20
What i used:
9/16 socket -1/4" drive. ( 3/8 will probably work with washer)
1/4-20 hex bolt. roughly 2" long.
Large 3/4" nut.
Pulled out pretty easily.
I did pour some PB Blaster on it as well. Not sure how much actually penetrated.
I'll send the rest of the pictures if all dont download in this batch.
Attachments
-
IMG_20240513_085454656.jpg187.8 KB · Views: 33
-
IMG_20240513_090709258.jpg195.1 KB · Views: 26
-
IMG_20240513_090345601.jpg253.1 KB · Views: 24
-
IMG_20240513_090211539.jpg167.8 KB · Views: 27
-
IMG_20240513_085621763.jpg152.1 KB · Views: 24
-
IMG_20240513_085549293.jpg157.3 KB · Views: 26
-
IMG_20240513_085546968.jpg159.3 KB · Views: 25
-
IMG_20240513_085528699_HDR.jpg137.8 KB · Views: 25
-
IMG_20240513_085524158 (1).jpg134.6 KB · Views: 25
-
IMG_20240513_085524158.jpg134.6 KB · Views: 34