Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
6.5 Creedmoor to a 6.5 PRC
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="swat" data-source="post: 1571028" data-attributes="member: 9861"><p>i have a big horn origin action with both the magnum, and 308 bolt face. my 6.5 prc shoots eldm 147 grain with the plastic tip squared off. they feed out of a magpul 308 mag with very little modification, and it will still feed the 6.5 creedmoor. i would think that it slows the round down some but it blew all the way through a 200 lbs whitetail at over 400 yds. the exit would was approx. 2 inch's. that was with the 143 eldx modified. you may have to modifiy the feed ramp on some guns but not this one. it only takes a dremal tool with a 1/8 " sanding bit. just my thoughts. great section. best part is you can put 4 prc rds in the plastic 5 rd. pmag.</p></blockquote><p></p>
[QUOTE="swat, post: 1571028, member: 9861"] i have a big horn origin action with both the magnum, and 308 bolt face. my 6.5 prc shoots eldm 147 grain with the plastic tip squared off. they feed out of a magpul 308 mag with very little modification, and it will still feed the 6.5 creedmoor. i would think that it slows the round down some but it blew all the way through a 200 lbs whitetail at over 400 yds. the exit would was approx. 2 inch's. that was with the 143 eldx modified. you may have to modifiy the feed ramp on some guns but not this one. it only takes a dremal tool with a 1/8 " sanding bit. just my thoughts. great section. best part is you can put 4 prc rds in the plastic 5 rd. pmag. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
6.5 Creedmoor to a 6.5 PRC
Top