300wsm 200.20x and 215 load data

[Crnaduckman]

Anyone willing to share load data with me with for 200.20x and h4350 or h4831sc? 300wsm plus p, 26" 1 in 8 twist, xm action, built for the 205 badlands which is no longer available and I'm almost out. It looks like most of the stuff I've seen is faster than the Berger manual. Obviously i am doing a ladder and working up to find pressure. But a couple solid loads will head me in the right direction. I am also gonna try the 215 Berger and the same powders.

 

[haisardao]

This rifle was build In a long action, and this load was safe in my gun, work up your load. Rifle shot great. I think I settled in 62 gr.

 

[Pootyng]

In my long action tikka 300 wsm 22" barrel I'm trying 200 gr eldx and using norma brass and Winchester brass with 215 primers. I no it's not the same bullets you're using but maybe it's something to use.
62 gr. H4350 2785 fps
62.5 gr. H100V 2800
65 gr. N560 2805

 

[MT-JONAS]

Following

 

[TexSavage]

This rifle was build In a long action, and this load was safe in my gun, work up your load. Rifle shot great. I think I settled in 62 gr.

I'm shooting the 215, 208, and 185 jugs in my Savage M12 BVSS, using a dead air primal, 26" factory, about 2,500 rounds and still holds .5 MOA.
In the 215 I'm using 65.6 grains H4831SC, it's a hot load. I was originally using 67.5 grains and according to QL and most folks, it was hot, but no pressure until I went with suppressor. SD has been between 6.5 and 9.5. Velocity on the 65.6 was 2756 and around 2800-2810 on the 67.5 grain load Norma brass.

The 208s are sub .5 MOA and SD of 6.3. Velocity is 2758 with 65.5 grains H4831SC. I just switched out to Lapua brass and no pressure signs, so redevelop loads but may stick with current loads as the are so dang consistent and accurate.

Using Norma brass I got pressure signs and the Norma brass was trashed after only 5 loads. All primers are LRM, CCI OR Federal, very little difference.

 

[MT-JONAS]

I'm shooting the 215, 208, and 185 jugs in my Savage M12 BVSS, using a dead air primal, 26" factory, about 2,500 rounds and still holds .5 MOA.
In the 215 I'm using 65.6 grains H4831SC, it's a hot load. I was originally using 67.5 grains and according to QL and most folks, it was hot, but no pressure until I went with suppressor. SD has been between 6.5 and 9.5. Velocity on the 65.6 was 2756 and around 2800-2810 on the 67.5 grain load Norma brass.

The 208s are sub .5 MOA and SD of 6.3. Velocity is 2758 with 65.5 grains H4831SC. I just switched out to Lapua brass and no pressure signs, so redevelop loads but may stick with current loads as the are so dang consistent and accurate.

Using Norma brass I got pressure signs and the Norma brass was trashed after only 5 loads. All primers are LRM, CCI OR Federal, very little difference.

Factory throat length? What speeds are the 185's?