6.5prc

This is an amazing custom rifle build by Pucker Factor Precision. This is a 0.4 moa rifle in high wind conditions even with factory Hornady 143gr ELD-X ammo. Just broken in ~20 rounds down the tube.I hate to sell, but we are looking to buy a house. Build: Defiance Classic SA BSF 6.5 PRC 1:8tw...

I come to this site often looking for tips and there seems to be a lot of knowledgeable folks posting here, can anybody direct me to some good resources for understanding and applying techniques for reloading? I've been working up a load for my 45-70 and getting decent results, now I have a...

I have an ultralight chambered in a 6.5 PRC. Does anyone know if they make an aftermarket bottom metal for the Ultralight to be able to have a higher capacity mag or will a bottom metal off a 110 scout be compatible? Tried to contact accurate-mag and savage service but have yet to hear back...

Hey guys I just acquired a new to me defiance deviant tactical action with an mpa 6.5cm barrel attached to it. I was planning on getting a magnum bolt for the deviant so I could have a 16.5” 6.5prc barrel spun up for it. My few questions are with the prc being a “6.5cm magnum” am I going to get...

Anybody have a Ultralite 6.5 prc with a muzzle brake? Looking for recommendation on a muzzle brake for my Savage 110 Ultralite 6.5 PRC. I want one that has the same OD as the barrel and clean looking. Thanks

Looking for 6.5 prc brass or dies for reloading thank you

My son and I spent some time in the reloading room working on a solid load for his Ruger 6.5PRC. I think we have found the load. Using once fired Hornady brass, hodgdon H1000 powder at 57.4gr, Hornady 147gr ELD Match leads and CCI 200 primers. We used the RCBS full length sizer just to push...

Hey guys I don’t know a lot about the 6.5prc but I do have a custom 6.5x284 1/8 twist that I built on a LA which gave me the ability to throat the chamber about 1/4 inch and run my bullet out farther, now I can run more powder and get faster speeds out of my 147gn bullet. Since I already have...

Does anyone know of an actual 10 round mag for a saum, short mag, or prc diameter case? I have done a little digging around and have not found one. I used a 7 round to shoot a PRS match last fall and felt like I lost a lot of points not having those extra 3 shots. I figured with the 6.5 prc, 6.5...

As the title states, does anyone know which Hornady Headspace Comparator should be used with the 6.5 PRC? Many thanks.