sticknstringer22
Member
Been shooting this 90 rounds. Bolt stuck around first box, got it with some force. Then 80 loads later 3 of the last shells stuck bad. Gun is getting sent in, wondering if anyone can tell anything from these pics.
Feeding issues/ bolt sticks question.
- Thread starter sticknstringer22
- Start date
Help Support Long Range Hunting Forum
Nobody can tell anything based upon those pics.
1. You say "box" and then "loads" so you shooting factory or hand loads or both?
2. If factory, the same amo?
3. Cleaning the chamber to remove possible carbon ring?
4. Borescope of chamber?
1. You say "box" and then "loads" so you shooting factory or hand loads or both?
2. If factory, the same amo?
3. Cleaning the chamber to remove possible carbon ring?
4. Borescope of chamber?
Last edited:
It's mighty dirty - clean the snot out of it. I see brass or bullet shavings, etc. Clean everything from the start of the rifling on back and start over.
sticknstringer22
Member
Hornady eld x loads, i have cleaned it with bore rope and barnes carbon cleaner, then dry swabbed it about every 10 shots as I broke in barrel. I used a bore guide every time which kept the chamber area untouched. I wiped inside of chamber with dry wipes a few times getting a but of carbon but not a lot. Was just curious if any one could see anything obvious. Gun seemed like a tight chamber as it chronograph high for the factory lot i was shooting. Thanks for lookin
sticknstringer22
Member
The bolt will not close and the shell will not feed all the way up. Needs another quarter inch to flush up and allow bolt to close. It's like the chamber /barrel moved. Accuracy was good on the gun.
Carbon ring is what I'm guessing.
MOA or bust
Well-Known Member
Are you running a suppressor? Sometimes flakes of carbon from the suppressor can fall back into the chamber and interfere with chambering.
Based on what you posted on your other thread it sounds like you've got a bad batch of Hornady factory 7PRC ammo? Is your rifle feeding all the other ammo fine?
www.longrangehunting.com
New to reloading
Yep, that's why I noted it as such in #26. Sorry, I wasn't doubting you,but when the OP showed the photos he confirmed what you said. I'm a seeing is believing type of guy.
sticknstringer22
Member
I can't get any ammo to feed in gun now. Only shooting a break, no suppressor. Gun is boxed up and getting shipped to Christensen tomorrow. Let them figure it out. Just thought someone here might be able to see something from the pics. A week before deer season so I'm switching to the weatherby.
K9TXS
Well-Known Member
Make sure you keep us posted on the issue and repair.
sticknstringer22
Member
Yep will do!!
