I was just wondering if you can keep primers to dry using those drying agents I forget what they're called my buddy stores his in ammo cans with a small bag of it in there. I'm wondering about long-term will it take too much moisture out of the primers any thoughts on this please
Primers "Too Dry ???"
- Thread starter tribb
- Start date
Help Support Long Range Hunting Forum
I don't think there's any moisture in primers to begin with.
Desiccant. Do a search, there are quite a few ways to store them with varying claims of which one is proper. Good luck!
Frank in the Laurels
Well-Known Member
- Joined
- Jul 15, 2007
- Messages
- 2,001
..I've used primers that were decades old and stored under about every condition imaginable with zero misfires in 6 decades of reloading..
Last edited:
Thanks
Great point had not thought of that! I live in Florida and sometimes it becomes necessary to leave before a hurricane blows your house down so to speak and I have to move them with me so they will be exposed to more than normal moisture at some point I'm sure! I'm trying to figure out a way to store them so I can remove any moisture that they may have gained in that process. If they have no moisture in them you surely can not over dry them I don't suppose!
Critter Picker
Well-Known Member
About the best containers I have found are ammo cans. I store all my rimfire ammo in them. And they have handles.
I also store my Prairie dog ammo in them. Open it up and it smells like fresh gunpowder. (That and Hoppies are what car air freshners should smell like ans don't forget empty shotshell hulls)
I also store my Prairie dog ammo in them. Open it up and it smells like fresh gunpowder. (That and Hoppies are what car air freshners should smell like ans don't forget empty shotshell hulls)
lancetkenyon
Well-Known Member
I live in AZ. No humidity here.
I love the smell of fired 22 short fires brass takes me back to 1955. Life was so good! I surely miss that time.
Fiftydriver
Official LRH Sponsor
High humidity and wide varying temps are the killers of primers and powder. High temps are bad, as are really low temps. I have primers that have been stored for 50 years at constant room temps, no special measures to control humidity and they perform just fine. Not saying there may not be some increased variations in flame temp and gas volume but they all consistently go bang.
I would not see any reason why a dessicant pack would cause any problems but also not sure they are needed unless living in very humid areas.
There are rumors that the federal government are trying to push requirements to use components that will intentionally degrade over time so that stockpiling components is not possible…….
