• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

270 Win Load with Norma Tipstrike or Sierra TGK

sjt18

Active Member
Joined
Jul 21, 2024
Messages
30
Location
Missouri, USA
Novice so please be patient. I'm still ignorant in a lot of ways which is why I'm hoping you guys can help me find good loads and stay safe.

Does anyone have any load data or suggestions for 270 win for either the Norma 140 gn Tipstrike or Sierra 140 gn Tipped GK with either Staball 6.5 or Ramshot Hunter?

Concerning these powders, are there equivalents or close equivalent powders out there? I have the burn rate chart but that just puts them in order.

One of the unique challenges I've found is that the Tipstrike seems to be shorter from Ogive to tip than most bullets. It doesn't look unusual but when I used the "redneck" method for measuring max seating depth I got between 3.25-3.26 OAL. I have a decent shooting load with the TGK at 3.360 (magazine max). I believe it is still .020-.030" off the lands. One hundred thousandths different for two tipped, 140 gn bullets seems odd.

With the Tipstrike it seems like pure experimentation. The bullet seems to be different enough from other bullets that published loads aren't that helpful.

Currently with Tipstrike I'm at 3.230" OAL with 54.5 gns of Hunter and no signs of pressure. That is .060" greater than Norma's data says. (The factory loads are about that too). The factory rounds are so hot that I got an ejector mark on a case but just better than the 3084 fps velocity. The current load is giving me an average of 2912. The SD was under 10. Only Nosler publishes a max load higher than 54.5 gns of Hunter for a 140 gn bullet- quite a bit higher at 56.5 gns.

I have loaded rounds to try 3 more steps at 54.7, 54.9, and 55.1. Am I safe with these? How high should I challenge it?


With the Sierra TGK and Staball 6.5, I grouped about .6 MOA which is good for me. The load was 55.0 gns seated at 3.360 yielding 2970-3000 fps. Anyone have something better I can try?


PS- Even if you have no input on the other I am curious if anyone else sees what I've seen with seating depth and velocity. On BOTH it seems that seating deeper has resulted in lower velocity. I would have expected the opposite. Is that just a matter of how efficiently the powder is being burned with more room in the case?

PSS- Why Tipstrike? The factory load outperformed every other bullet I tried both for V and accuracy. I also found a great deal on them at Raven Rocks. On sale- $19.95/100. All of the reviews looked good if not great for the bullet performance.
 
Use any 140gr load data that is for cup N core bullets. Of course start low and work up.

I load RL16 & 136gr TA at 3150 from a 24" tube

 
This is a page from Sierra, you need to use your max mag length for your oal.
Sierra shows 3 different lengths for 3 different shaped 140gr. Maybe one of those 3 will work for you.
I typical start 20 thou off mag length and go back from there.
Hope this helps.
 

Attachments

  • 20241011_170238.jpg
    20241011_170238.jpg
    165.7 KB · Views: 40
Your probably looking for something in the RL22 burn range.

Your Hunter is close to the RL19 burn. With the Staball 6.5 being slightly faster.

Unfortunately, many of the powders listed in the Sierra manual with the higher velocities are either discontinued or you can't get right now.

I'd be looking at Norma MRP (essentially RL22), IMR 7828, and Vihtavouri N560. Those should be available.
 
Your probably looking for something in the RL22 burn range.

Your Hunter is close to the RL19 burn. With the Staball 6.5 being slightly faster.

Unfortunately, many of the powders listed in the Sierra manual with the higher velocities are either discontinued or you can't get right now.

I'd be looking at Norma MRP (essentially RL22), IMR 7828, and Vihtavouri N560. Those should be available.
 
Use any 140gr load data that is for cup N core bullets. Of course start low and work up.

I load RL16 & 136gr TA at 3150 from a 24" tube

Where did you find 136TAs as a component??
 
If you go to midsouth shooters supply, look up your 140gr tipped gk, in description, they have a link to sierra load data. They list Hunter, but not staball.

49.3 min , max 55.5 with a 3.3 coal.
 
Where did you find 136TAs as a component??

Not where I bought them but available here.


 
Last edited:
Novice so please be patient. I'm still ignorant in a lot of ways which is why I'm hoping you guys can help me find good loads and stay safe.

Does anyone have any load data or suggestions for 270 win for either the Norma 140 gn Tipstrike or Sierra 140 gn Tipped GK with either Staball 6.5 or Ramshot Hunter?

Concerning these powders, are there equivalents or close equivalent powders out there? I have the burn rate chart but that just puts them in order.

One of the unique challenges I've found is that the Tipstrike seems to be shorter from Ogive to tip than most bullets. It doesn't look unusual but when I used the "redneck" method for measuring max seating depth I got between 3.25-3.26 OAL. I have a decent shooting load with the TGK at 3.360 (magazine max). I believe it is still .020-.030" off the lands. One hundred thousandths different for two tipped, 140 gn bullets seems odd.

With the Tipstrike it seems like pure experimentation. The bullet seems to be different enough from other bullets that published loads aren't that helpful.

Currently with Tipstrike I'm at 3.230" OAL with 54.5 gns of Hunter and no signs of pressure. That is .060" greater than Norma's data says. (The factory loads are about that too). The factory rounds are so hot that I got an ejector mark on a case but just better than the 3084 fps velocity. The current load is giving me an average of 2912. The SD was under 10. Only Nosler publishes a max load higher than 54.5 gns of Hunter for a 140 gn bullet- quite a bit higher at 56.5 gns.

I have loaded rounds to try 3 more steps at 54.7, 54.9, and 55.1. Am I safe with these? How high should I challenge it?


With the Sierra TGK and Staball 6.5, I grouped about .6 MOA which is good for me. The load was 55.0 gns seated at 3.360 yielding 2970-3000 fps. Anyone have something better I can try?


PS- Even if you have no input on the other I am curious if anyone else sees what I've seen with seating depth and velocity. On BOTH it seems that seating deeper has resulted in lower velocity. I would have expected the opposite. Is that just a matter of how efficiently the powder is being burned with more room in the case?

PSS- Why Tipstrike? The factory load outperformed every other bullet I tried both for V and accuracy. I also found a great deal on them at Raven Rocks. On sale- $19.95/100. All of the reviews looked good if not great for the bullet performance.
Finally, another person using Tip Strike bullets. I have tried many bullets in my 243AI with mediocre success. Then I tried their 76 gr 6mm bullet and it all came together. Oh, the 6mm bullets were also $19.95 per 100. Now, they are almost $25.00. Glad I got 500 right off the bat.
 
Weirdest thing. I walked the powder up a little more today. 54.7, 54.9, and 55.1. All were slower than my earlier 54.5 load.

Any ideas?
 
Weirdest thing. I walked the powder up a little more today. 54.7, 54.9, and 55.1. All were slower than my earlier 54.5 load.

Any ideas?
So it reacts like RL17.

RL17 is known to increase velocity with charge weight increase to a point. Then even though you increase charge weight, the velocity will decrease.
 
So it reacts like RL17.

RL17 is known to increase velocity with charge weight increase to a point. Then even though you increase charge weight, the velocity will decrease.
Could be. I'm also learning about the effects of humidity on powder. My reloading place isn't climate controlled. I store in the driest place I have but it can be humid where I measure
 

Recent Posts

Top