drabdrew
Member
Thank you. Didn't know that same post could be updated
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Hammer Hunter Load Data, (See page 1, Post 8)
- Thread starter GLTaylor
- Start date
Help Support Long Range Hunting Forum
Hammer has load data on their website now.
Load Data - Hammer Bullets
Hammer Bullets® Load Data Shooting firearms can be dangerous. Firearms and reloading equipment not taken care of can lead to catastrophic failure, danger, and death. Environmental conditions can drastically impact firearms, powders, and primers. Companies may update components such as powders...
hammerbullets.com
This has been a great service for our members. I have had great results in my testing with HH143 in a 280AI. Of course I can't leave well enough alone. I just received 100 HHT145's and need to start my testing. BTW - installing the tips was super simple. Target powders are RL23, H4831sc, and H4350 as of right now. Any suggestions to be mindful of, or should I just roll with HH143 base loads?
Mark if it was me I'd send a few at your 143 charge using same distance off. Then maybe tweak from there maybe not. Show us the groups when you do. Good luck!
The most consistently accurate load for the HH143 in a 8T 24" 280AI:
4831sc 60 grains
Fed 210
Peterson new brass
COAL - 3.3500 .025 off
3170 FPS
.5 MOA and no pressure signs
4831sc 60 grains
Fed 210
Peterson new brass
COAL - 3.3500 .025 off
3170 FPS
.5 MOA and no pressure signs
Rick Richard
Well-Known Member
7SAUM
22" Proof 1-8 suppressed
ADG twice fired.
143 HH
H4350 58.5
CCI 250
3031 fps
ES 23.0
SD 9.8
100 and 200 yards
22" Proof 1-8 suppressed
ADG twice fired.
143 HH
H4350 58.5
CCI 250
3031 fps
ES 23.0
SD 9.8
100 and 200 yards
drabdrew
Member
Heres a really cool one there isn't any data on:
25WSSM
22" Mod70 featherweight
Winchester brass 2x
95HHT
WLR
COAL 2.3300"
H4350 / Varget
45gn- 3167 / 41gn- 3104
46gn- 3260 / 42.6gn - 3260
47gn- 3294
25WSSM
22" Mod70 featherweight
Winchester brass 2x
95HHT
WLR
COAL 2.3300"
H4350 / Varget
45gn- 3167 / 41gn- 3104
46gn- 3260 / 42.6gn - 3260
47gn- 3294
ncfireman83
Well-Known Member
Need twist rate for both barrels above?
Also, @drabdrew , please verify your listed charges. They are scattered about quite a bit?
@ncfireman83 , need brass, primer used and OAL loaded, please.
Thanks guys
Also, @drabdrew , please verify your listed charges. They are scattered about quite a bit?
@ncfireman83 , need brass, primer used and OAL loaded, please.
Thanks guys
Last edited:
Folks out there, do y'all have any new loads for 26 Nosler using 124 HH that are not in the @GLTaylor compiled list?
I am thinking pressure test start with
81.5 Retumbo increment 0.5, Nosler brass 3X fired, CCI Magnum. COL 3.56X. Barrel is 25.5 KBI 8T. Tried 700 in a sendero stock. March scope 2.5-25x52. Banish 30 gold muzzle brake, 5/8x24. Can should be here in a a week or so. Will run pressure test without it.
I am thinking pressure test start with
81.5 Retumbo increment 0.5, Nosler brass 3X fired, CCI Magnum. COL 3.56X. Barrel is 25.5 KBI 8T. Tried 700 in a sendero stock. March scope 2.5-25x52. Banish 30 gold muzzle brake, 5/8x24. Can should be here in a a week or so. Will run pressure test without it.
mdmiller
Well-Known Member
Call Steve tomorrow.
Well, went to the range today. I loaded 4 with 81.5 rounds to get the newly installed scope in the middle after boresight. I did not even get past the 81.5 as the bolt lift is on the hard side to my liking.
Pictures tell the tale. 3rd shot is on the target. Put rifle aside, shot the 7RM for a while, then shot the 4th round.
Edit: 4th shot is 3655.. wrote it wrong
Edit: temperature was 93
Last edited:
That's smoking fast! And accurate.
