• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Bullets backing out of case...thoughts?

8x68s

8x68s

Well-Known Member
Joined
Apr 9, 2019
Messages
1,501
Location
Salem, Oregon
Not happening to me but I have heard of it happening. Specifically in a very full or powder crushing load. (Not recoil induced.) What is the cause? I'm wondering if powder has "spring back" capability or is it the trapped air in the cartridge case expanding as one goes into higher elevation locales? What got me thinking about this is the expansion and contraction of empty water bottles coming and going to higher elevation hunting areas.

I look forward to your opinions... thanks!
 
A compressed powder load does exert pressure on the bullet. If it is compressed enough it will push the bullet out of the case, especially with a little vibration like travelling in an MTM case. You either need enough neck tension or a light crimp if making compressed loads. That or load at the range and shoot them right away.
 
Last edited:
I had that happen to me when I was experimenting with compressed loads.
While the manual said "C=compressed" it didn't say how compressed.
QL was telling me 110%.
I tend now to look for charges 85-100%.
 
Compressed powder easily pushes on a bullet forcing it out of the neck.
I have had this several times, slightly compressed often shoots the best groups, but too much of a good thing can bite you in the butt.
I have to seat my 230g loads just prior to a match for this very reason in my 300WM, the bullets will move out of the case .030" overnight, so this is what I do. It would be pertinent to switch powders, but it works so well, I just can't seem to change it…

Cheers.
 
Mark37082 said:
I had trouble with compressed loads. Those long monos and RL23 didn't get along for me. Rechecked several after seating and sure enough, they had backed out significantly. I was running .002 neck tension.
Click to expand...

I had the same issue with .300 WSM and the TTSX bullets.
 
skipglo said:
Easy answer....don't compress loads!
Click to expand...

When I was trying to get the TTSX bullets going in my .300 WSM that is the conclusion I came to. Longer for weight bullets can result in compressed loads.

I ended up immediately with severe pressure signs and decided compressed loads are not for me.
 

Similar threads

G
Primers backing out.
2 3
Replies
38
Views
6K
Seabeeken
Seabeeken
M
Primers backing out!!
Replies
7
Views
3K
cva54
C
T
243 Win Backing Out Primers
2 3
Replies
29
Views
6K
243winxb
243winxb
F
Thoughts of Hornady's New 3‑in‑1 Power Case Trimmer
2
Replies
14
Views
804
Axl
A
A
Case Neck Run-Out
Replies
10
Views
3K
Moman
M

Recent Posts

Top