I just got a new side baffle break with a crush washer it's from Christensen. It seems to take a lot to get it in-line with the bore. Is that pretty normal? Thanks for any input! I actually ordered 2 of them one is for my 300 PRC and the other is for a 300 rum. The 300 PRC barely took any resistance to put it on but the rum didn't line up as well so it took more force to get it in line with the bore!
Muzzle break/ side baffle
- Thread starter SHEDKING
- Start date
Help Support Long Range Hunting Forum
It depends on the muzzle brake and the type and thickness of the crush washer(s)/shim kit that came with it as it relates to the muzzle thread.
Christensen Arms side baffle breaks! One was just took way more torque to get to position. Must just be the way it was threaded. See how they shoot tomorrow. I have another Christensen in the traverse and just seems to really tame that rifle.
Yep, make sure you follow the recommended torque value. I have various types of muzzle brakes and have been using them since 2003, but I have yet to use any with washers/shim kits. All non-self-indexing muzzle brakes are GS-timed/installed, requiring no washers/shims. I also use self-timing muzzle brakes from Muzzlebrakesandmore, PVA, Benchmark, Piercision, Blast Tamer (CSR), etc. My latest one is an EC tuner brake.
Good luck and have fun with them.
I'll usually sand the base of the brake or use shims to get my alignment with the amount of torque I want. If I absolutely have to use a crush washer I'll tighten and loosen it a few times to loosen it's force up a bit. It's not what you're "supposed" to do, but it works quite well.
Zen Archery
Well-Known Member
- Joined
- Dec 27, 2012
- Messages
- 1,523
This...
If I had to sand, it would be the back of the shim. But that's just me.
Varmint Hunter
Well-Known Member
I had a brake on a 458SOCOM that needed a crush washer. The washer was misplaced, and I needed a replacement. Just for the heck of it, I put a rubber O ring on the treaded bbl and screwed the brake on. Everything lined up fine but I didn't think the O ring would work well or last long. I was wrong on both accounts. Oddly enough, I had no problems using the O ring.
That's an interesting little piece of info. Never considered that.
The only one I've ever installed was from Muzzle Brakes and More and I treaded the barrel so it was not difficult to line up. It tamed my 300 WM down to a 243 or less.
It works great but don't forget the ear protection.
I have several of Nathan's MBs, but they are mostly self-indexing. MBM does an excellent job of reducing felt recoil and muzzle rise. I believe the MB below was the last non-indexing MB I purchased from him for my 7MM SAUM.
I had my GS thread the barrel and taper the MB.
Yes, some kits have different thicknesses (https://www.wingtactical.com/firear...-tactical-muzzle-device-alignment-set-5-8x24/), and some have the same thickness (i.e., 5 of the same - https://christensenarms.com/product/crush-washer/), but the OPs came with a crush washer (https://christensenarms.com/product/titanium-side-baffle-brake/) with the right thickness for proper indexing.
Last edited:
