Sling Bolt Head Touch Barrel
- Thread starter SecretSquirrel38
- Start date
Help Support Long Range Hunting Forum
The other option might be to run a nylon washer between the swivel and the stock and that should gain you some clearance on the inside.
ofbandg
Well-Known Member
Stick the tip of it on a grinder for two seconds. That is what I have always done.
I was going to say to use a Dremel tool with a very fine grinding drum to take it below the wood. On the other hand the barrel has obviously not been floated. Try glass bedding and floating the barrel. That should cure your contact problem and increase the rifles accuracy too.
Bucklowery
Well-Known Member
Yes during bedding I use electrical tape around the barrel to center in the stock and set the gap I want between the stock
Thanks
Buck
Thanks
Buck
Critter Picker
Well-Known Member
X2 on the Dremel tool.
Laelkhunter
Well-Known Member
Just wondering how it shoots the way it is? My Weatherby has an upward pressure point and it shoots pretty good. It looks like your rifle has been used, so I was just wondering if it shoots good, or are you having accuracy problems and found this in your search.
I have only shot it about 15 times because it rattles my fillings. It was given to me. I got it to 2.5 inch groups, got a deer at 358 yards 2 years ago and stuck with my 270 since.
Last edited:
Laelkhunter
Well-Known Member
Good Luck. Let us know if grinding the stud down helps with the accuracy. You can try putting one of those slip on rubber recoil pads to help with the recoil.
Recent Posts
-
What effects blood trails more, BH selection or shot implementation?
- Latest: Allen Lone wolf
-
-
-
-
