Rflshootr's latest activity

I wonder what the price of ammo is. I'll guess probably enough to make it a flop.

https://www.federalpremium.com/backcountry.html?utm_source=Klaviyo&utm_medium=campaign&utm_campaign=01%2F07%2F25%20It%27s%20here%20%28clo...

Yep! That must be it! Or it's a weld bead to close a hole in the barrel material.

Those are obviously tuning marks to zero the bullet flight pattern.....or factory hiccups

Let's just suppose you're right. Let's say that the button galled up and made that mark. Explain to me why it's only in that very short...

I've seen brass cleaning jags ding crowns. You don't think a stainless rod with a sharp edge could cause damage? Especially without a...

Buttons don't cut. They swage. Lack of lubrication during the rifling process maybe, but if that were the case, it would most likely run...

Or the end of an uncoated stainless steel cleaning rod that the brush or jag was slightly smaller and getting a tight patch...

Humidity man, humidity! Never store a gun in a room with a hot shower. Unless you are Big Jake, then you shower with a shotgun.

Remington has used both in the 308. It depends on the model. I have a 308 700 VLS with a 12 and a 700 BDL with a 10. They have made...

So, would you like to elaborate on what you may have done to think you may have caused it?

Do you mean to tell me that you only use a plain jane 308 and didn't have one of those newfangled magnums that hold 300 grains of powder...

Tag

The more I think about it, unless you don't care how the rifles shoot and you just want bullets to come out the end of the barrels, the...

I'd cut the lug surface back .030-.060 and just bed the lug area with whichever action you pick. From there, it is what it is.