Recent content by DebosDave

Offers?

I guess the root of my question is based on this being a hunting site. Whether it is referring people to a reloading site or not, I find it odd that there is limited discussion about reloading practices, especially considering a "good" ES of 25fps would be considered adequate in most hunting...

I am aware of the BR shooters, the ES and SD conversations come up regularly in those circles

Hello everyone, I have a question that has been on my mind for quite a long time. I have observed from a distance the ELR conversations and have digested my fill of which bullet, caliber, optic and so forth. One thing that I have failed to observe is based in the reloading aspect. I know...

There was a weird "transition" period after Barney got sick, I think that is when they may have intermittently used some other actuons before they went to different model designations...

oh, and dies LOL

That sure sounds interesting!! What would you take for the barrel, bolt, and brass? How does this compare to the 7mm Ultra? Do you have load recipes?

1 box .378 Weatherby factory 270 grain spire points. I have had this box kicking around since I got rid of the rifle. Just want to pass it along if someone is looking. I will do $80 shipped, this is basically just over the cost of the brass and shipping. Box is rough, but ammo should be...

wrong section

They tried to make a go for a while. I think someone in the Bitterroot valley purchased out their equipment and maybe tried to continue making some actions and rifles, but I don't think they are still in business either.

Joel, Do you still have bottom metal and inlet stocks for this action? Thanks!

Do you have the .416 barrel as well? Thanks!

Anyone out there have any ideas where a guy could source a bolt for a Lawton 8000 action (CheyTac M310 should also work)? Have tried to search for a switch barrel hoping someone would split one off, but not having much luck... Thanks in advance

Thanks for the input so far! I am keeping my eye open for something used that is a reasonable distance from me. I looked at the small grizzly gunsmithing lathe, but am maybe hoping to find something used cheaper, well for less money :)

Just looking to get some opinions on the above title. What are the thoughts on the smallest practical lathe for jobs like threading and chambering? Thanks!