Kmccord

The coax jaws need to have some play so they can move, if one jaw is a little farther out than while holding case wouldn't this can't...

A die needs to squeeze the shoulder and base of the case the correct amount. It also needs to push the shoulder back the correct...

Depends on how far down the rabbit hole you want to go. Some call it OCD, some call it an**. Starts with fixing things that were not...

The following day they sent me a prepaid UPS label. I boxed it up and shipped it out that day. Two days later I had a new Garmin. I'd...

Short action? 6.5SS XM? Flip a coin. ' But if you have an XM... Don't forget about the 6.5Max (SAUM Imp 40*) Or the 6.5Mega Or the...

Was just gonna suggest the same

I would call the place you purchased it and tell them the problems you are having, I am sure they can advise on what to do or send you a...

I bought a RCBS Rebel press a few year ago - serves me well. I have Dillon 550s too and I often use the Dillon 550 to seat PRS cartridges.

The press has very little effect on run-our as long as it is in decent shape. The dies you use and your procedure have a much greater...

This!! ☝️ 🤣👍👍 I don't worry about +/-.002 runout in reloads, then again I am happy with groups in the .2's and .3's... I think...

The type of bullet, die, seating stem all come into play with bullet runout. I use vld style bullets mainly and have matching stems...

I don't want to drive to the donut shop. It's straight to the eggs and sausage.

What about bullet runout? That has been my dilemma, I can size my cases without the neck sizer in my FL die and will run from .0001 to...

I look at it as the cost of Proof/Bartlien/Benchmark carbon barrel. On top of that it is used more than any one barrel. Put in that...

I went from an old Lyman turret press t a Redding turret press and could not be happier. That Area 419 sure looks impressive, but I will...