WYO300RUM

New brass with ADG, Lapua and Peterson. I size the necks and chamfer and deburr the necks

Brass needs to be fire formed to your rifle anyway so just run a sizing mandrel through the neck to straighten any dings. If you don’t...

I used Reloder 26 (54.5gr. that particular group) with a 147 gr. Hornady ELD-M, Lapua brass and Federal 210M primers. I was also...

I do the same, just chamfer and debur

Nice work. Care to share the bullet and powder details?

I do the same, full length size, chamfer & deburr, measure and trim if needed

For many years, I loaded new brass right out of the packaging. UNTIL the neck ID of a batch of Lapua 6.5-284 brass was so tight that I...

I use the Lee collet to neck size as I indicated earlier for new brass. I also use it as the second step after shoulder bumping with a...

This absolutely improves accuracy. I did many, maybe ten, five shot groups each with factory and squared heads.

I recently purchased 150 ADG .28 Nosler brass for a wildcat. Just to be sure, I stuck my primer hole uniformer in one. There was a...

My efforts are to start at the same point every time. I process my brass the same way no matter if it's new or fired. Full length sizing...

New brass never been fired. I go through the brass and see how much the brass varies in length. Set up my case trimmer and cut all to...

I usually at least try to run an expander ball through brass just to get the necks straight and the right size. I have some new Dasher...

I use Lapua, Peterson, and ADG brass. I run a mandrel thru the neck for consistent bullet seating, chamfer, deburr, load, and send it...

Same. With new brass I mandrel, chamfer, debur, load and shoot. I don’t even start load dev until after the first firing.