TonyRumore

Years ago, I attended a Soviet Weapons Armorer's course at Front Site in Arizona. We fired the PKM machine gun until the barrel was...

Yeah, I would definitely start low and work up. A guy on another board thought "similar" was "equal" and went way over pressure...

I use an RCBS Ammomaster 50 BMG press for the big ones. The press is threaded 1-1/2" and I have bushings for the 1-1/4" and 7/8" dies...

While hunting, I prefer a shoulder holster. Tony

Here ya go.

Looks like a decades old Sierra Silhouette bullet. Tony

I have over 200 different powders on hand including some Vectan. A24, Ba10, Ba9-1/2, AO, Ba7-1/2, Ba6-1/2, and Tubal 8000. I have only...

I would just go with a 30-378 Weatherby. Tony

Wow....It's nice to finally match up a face with the famous Hitman name. For those that don't know, Hitman wrote featured articles for...

There are very few barrel makers that can do that 1:3 twist. 1:5 is the normal limit for most. If you're planning on shooting subs...

The scope mount sits parallel to the bore. Tony

That sounds like a good plan. However, I am guessing the scope/reticle is setup to be installed on a 20MOA downward slanting mount...

It came on a Pauza P-50 semi-auto 50BMG when I bought the gun. Tony

I'm not exactly sure how I'm going to get this sighted-in at shorter ranges. Starting off with a newly mounted scope at 500 yards, is...

That bullet is extremely accurate in every single 6mm gun I have ever tried it in. They also kill deer quite well. I've been using it...