Case forming question.

VON GRUFF

Member
Joined
Mar 22, 2009
Messages
10
Can a 9.3x64 case be formed down to the 7x57 case size sucessfully. Will the standard bolt head except the bigger case head with out it being turned down. I do have genuine reason for asking this as I want to create a thick neck case to look at a few accuracy issues. I have been handloading for 35+ years so understand the safety side of load developement, release clearance, tapered neck idiosyncrasies, etc etc etc. I would like to know if the case head will re-form and the rim issue before I buy the expensive brass.

Von Gruff.
 
Warning! This thread is more than 16 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top