Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
6.5x284 Norma Reamer
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="IdahoCTD" data-source="post: 1122609" data-attributes="member: 13110"><p>Factory Hornady 6.5saum brass is suppose to be done the end of October.</p><p></p><p>If your using a long action you have all the room in the world to seat a 140. If it's going in a short action the mag length will dictate the throat length. Typical reamers are 1 degree 30 minutes of throat angle. If your ordering a reamer buy some new brass, seat some bullets to mag length (short action) or where the edge of the boattail is at the bottom of the neck (long action) and send them in as samples. I usually order my reamers .003" over loaded neck diameter but some people don't like them quite that tight. .003" to .005" is a good range.</p></blockquote><p></p>
[QUOTE="IdahoCTD, post: 1122609, member: 13110"] Factory Hornady 6.5saum brass is suppose to be done the end of October. If your using a long action you have all the room in the world to seat a 140. If it's going in a short action the mag length will dictate the throat length. Typical reamers are 1 degree 30 minutes of throat angle. If your ordering a reamer buy some new brass, seat some bullets to mag length (short action) or where the edge of the boattail is at the bottom of the neck (long action) and send them in as samples. I usually order my reamers .003" over loaded neck diameter but some people don't like them quite that tight. .003" to .005" is a good range. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
6.5x284 Norma Reamer
Top