Recent content by Kmccord

Are you using an MB2 Wyatt's Extended mag? I was having issues with the Wyatt with the spring providing to much pressure causing it to feed incorrectly and scratching the brass. By using a vise I took majority of the tension out of the spring and it feeds flawlessly. You don't have to go to...

That is a good thing with them standing behind there product.

I have two of them one in 6 Creed and another in 6.5 PRC, I just ordered a 7 PRC this afternoon. I went with Taperless 750 on all three builds, two are diamond fluted and one is spiral fluted. The 6 and 6.5 are on Kelbly Atlas Tacs and the 7 will be on a Terminus Kratos Lite. They are...

Looks like my 6 Creed barrel, 750 Taperless with 1:8 Spiral fluting. I am curious to see how well it shoots now.

Something else I am going to try, I am going to build a puller like the one LRI sells for pulling the action straight out of the stock. I have some aluminum angle iron I will use, if I cannot build it correctly, I will buy the one LRI has online.

Yes, that is what I noticed on a build I have using an AG stock, the action and barrel would be sloppy when loosen the action screws, I had sub moa without bedding. Now with the action bedded, it doesn't wiggle when you loosen the screws. I used JB weld as well and it worked fine and Hornady...

Have you shot it yet to see if any improvement were made on group size?

I wanted to hear if anyone has used PBB Carbon wrapped barrel's, are they accurate, any problems with the carbon wrap peeling or they as good as some of the other carbon barrels on the market, proof, benchmark etc ?

Are you shooting out of this house as well?

You cannot beat that for customer service, glad to hear it.

Have you thought about making the countertop with concrete? Just build the frame and pour, it would be more work and time consuming, but it will definitely last a lifetime and cleanup very well.

Are you referring to the Universal bullet seating die? I have that one as well, it has held up to the accuracy as my specific dies for specific cartridges.

I have the M Press I had it for several months and noticed a little play in the shell holder assembly. I contacted them and sent a video of what I was seeing, I was expecting them to say that was normal, but what they asked was for my address. What I received in the mail was a new M Press...

I have not done any loads on it. Just used factory ammo to test it out. This will be sold once I finish with the Cerakote.

Is the rifle bedded? Also, have you picked up some factory ammo to see if that has any difference in groups, just to rule out anything that you may not be seeing during reloading? I have 6mm Creed PBB barrel I have built on a Kelbly Atlas Tac and it is accurate, but I have only test fired it...