Winchester SX4 Bolt Slide Assembly, 20ga.
- Thread starter Doghunter23
- Start date
Help Support Long Range Hunting Forum
Doghunter23
Well-Known Member
I broke my boy's 20 GA sx4 by pulling out the bolt handle for disassembly. I failed to realize you need to depress that little stamp meatal tab in the bottom (shell stop) before you can pull the bolt handle out!
So I ordered a new shell stop, my question is can I just drive the pin holding that shell stop out with a correct size punch and a bolt block?? The pin in question is highlighted by screwdriver.
I don't want to cause any additional damage.
So I ordered a new shell stop, my question is can I just drive the pin holding that shell stop out with a correct size punch and a bolt block?? The pin in question is highlighted by screwdriver.
I don't want to cause any additional damage.
Doghunter23
Well-Known Member
Information on this shotgun is nonexistent online.
Doghunter23
Well-Known Member
And Winchester won't share any information.
Doghunter23
Well-Known Member
Update, came right out with the punch. Replacement took 5 minutes, just don't let tiny spring go flying.
