Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Tikka 243 Bolt hard to close 25% of the time?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="WEATHERBY460" data-source="post: 2187499" data-attributes="member: 20666"><p>I have a tikka 243 that with factory ammo, the bolt is hard to close about 5 out of 20 rounds when using factory nosler and winchester ammo. When i close the bolt, then push the bolt down to lock it, is when the most resistance happens. I am noticing a slight mark on the back of the case, possibly caused by the ejector pin. This mark shows up even before i fire the round. I did have the front base screw sticking down in the receiver so I shortened that, but that did not help. Any ideas?</p></blockquote><p></p>
[QUOTE="WEATHERBY460, post: 2187499, member: 20666"] I have a tikka 243 that with factory ammo, the bolt is hard to close about 5 out of 20 rounds when using factory nosler and winchester ammo. When i close the bolt, then push the bolt down to lock it, is when the most resistance happens. I am noticing a slight mark on the back of the case, possibly caused by the ejector pin. This mark shows up even before i fire the round. I did have the front base screw sticking down in the receiver so I shortened that, but that did not help. Any ideas? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Tikka 243 Bolt hard to close 25% of the time?
Top