Savage 110 LA Stock Options

[WYOHTF]

I've used this stuff, both the liquid and putty. it's good stuff to work with.

I was unaware of the liquid.
What was it like to work with and where did ya use it ?

 

[WYOHTF]

how big was the pond? sounds like a great deal!!

The po d was pretty big had to swim for all the geese, damned dog
It a little more expensive from what I remember.
This, I am sure isn't the same seller. That was three yrs ago.

Devcon 10110 Plastic Steel Putty -1lb for sale online | eBay

Find many great new & used options and get the best deals for Devcon 10110 Plastic Steel Putty -1lb at the best online prices at eBay! Free shipping for many products!

www.ebay.com

 

[Deleted member 109523]

I was unaware of the liquid.
What was it like to work with and where did ya use it ?

I,ve used it on 2 rem 700's, a howa, and an XPR. The stock needs to be sealed (dammed) much better, and you'll have more run over. But once I got it down, it was much better. Less air bubbles. I didn't use it on my next XPR, because it was almost impossible to keep it dammed back by the trigger ***.
I have to do a savage soon, and it's similar. So I will be using the putty.
There's a great video you can rent from, https://www.ballisticstudies.com/ through vimeo, for I think 12 buck, that I used the first time.

 

[WYOHTF]

I o see if ya can mix the two of them ? Make the putty a little more manageable

 

[Deleted member 109523]

I o see if ya can mix the two of them ? Make the putty a little more manageable

I have both. I'll have to mix a little of the two on a board and see how it dries. Love being retired.

 

[Deleted member 109523]

the steel liquid is PN 10210

 

[biff's reloading]

I've tried liquid and putty. And jb. And a few others. Devon 10110 is definitely my favorite. I try to geta big front pad, then just a tab and band for the rear. this one is curing up now. I had to add a bit to fill a void.

Let it set up 4 or 5 hours and pop it apart so u can trim the boogers up nice with a razor. Then screw it down tight to finish up curing.

 

[ntsqd]

Devcon Aluminum putty is my favorite. Stronger than the steel putty and less shrinkage.

 

[biff's reloading]

 

[Deleted member 109523]

Hmmm interesting. Thank you

 

[xsn10s]

I believe the shrinkage is less with the steel putty too.