Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Questions about reamers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="2Ldude" data-source="post: 1550127" data-attributes="member: 104823"><p>So using that figure if I went with the 180VLD it would give me even a little more wiggle room to find the seating depth the barrel/bullet likes correct ? My intent with all this is to have something in the lines of an 7STW but not have to find hard to find brass, etc. Just neck down the 300 Weatherby to 7mm cal</p></blockquote><p></p>
[QUOTE="2Ldude, post: 1550127, member: 104823"] So using that figure if I went with the 180VLD it would give me even a little more wiggle room to find the seating depth the barrel/bullet likes correct ? My intent with all this is to have something in the lines of an 7STW but not have to find hard to find brass, etc. Just neck down the 300 Weatherby to 7mm cal [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Questions about reamers
Top