• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

OK I need help!

80 and even 84 grains of h-1000 seems low to me, I am running 89 - 91 of h-1000 with my 338 lapua and the 300 SMK's with Lapua once fired brass and having no problems at all. I will admitt I have never heard of this one before but it may be to light of a load density causing the problem. Also was wondering if you are FL sizing the Lapua brass or not. If it was shot in a rifle with a larger chamber it may be why it is sticking in your fairly new and tighter one. FL sizing may help with that
 
Last edited:
I thought 80-84 grains was really low to I was all the way up to 90 before and i got a new batch of H-1000 and had to drop it a lot probably more than i needed but i didn't want to have to mess with it any more during hunting season. Is it possible that the low amount of powder does not make the new stiffer bass fluid enough to return to the size it was prior to the shot?

To answer a few other questions i am using full length dies and they chamber great before I shoot but they dont chamber at all if i dont size them they will just get stuck like the ones I have shot.

thanks
val
 
You state your bolt moves freely? Does it move up 1/4 of the way then stop or are you
jumping the extractor completely over the rim?
 
My bolt moves about three quarters of the way up and stops it does not jump the extractor.

And i agree with everyone 80-84grs seems extremely light to me as well.
 
I checked out brassmanbrass.com and he advertises once-fired Lapua brass. I wouldn't jump to the conclusion that his brass is fired more than once, but I'd say at the very least it was fired in a chamber that was looser than yours.

Just ahead of the web the brass will swell. FL sizing doesn't always bring the brass back down to spec. This is more of a problem after it ahs been fired 8 or 12 times and begins to work harden.

I have witnessed this with my rifle and there is no cure for it that I know of. I usually get about 10 firings on my Lapua brass but I've gotten as many as 16 firings. Once they harden to the point that they are difficult to extract, they are done.

I would suggest you buy some new (unfired) Lapua brass and I expect your problems will be over, at least until you have 8 or 10 firings on them.

I have thought about looking into buying a custom small-base die to see if I could extend the life of my brass but it seems that after 10 or 12 firings that I've got my money's worth from them.

Good Luck, Festus
 
I think I am going to go with Festus and buy some virgin brass any of you interested in about 90 pieces? HaHa I understand if you don't want anything to do with them!

Thanks everyone I would be completely lost without this site,
val
 
Warning! This thread is more than 14 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top