Developing some 300 blackout subsonic stuff. I have a question for those of you that have quickload. Viht n133 sits right between IMR and hodgdon 4198. plenty of data on 4198 but none on N133. Hodgdon shows a 208 amax subsonic load of 11 grains of 4198 it also shows a 16.9 grain compressed load in a bullet similar so the bulkiness is real close as you will see below.
I have a swaged 190 hollowpoint jacketed I would like to use along with n133 as I have 16#.
After seating bullet, there is 1.03 inches left for powder in the case. I filled the case to where the bullet would not compress the powder and then weighed and came up with a 100 percent fill non compressed as 15.9 grains .
11 grains of n133 would give a 69% 10 grains is 56% fill of remaining case after seating.
Anyone got quickload and help me out here?
Trying to make sure i don't get into pressure issues or secondary explosion. Rule of thumb for fast powders would be never go below 30% fill. certainly nowhere near that just looking for some advice I'm a mac user and have no way to use quickload.
can someone run this for me please?
I have a swaged 190 hollowpoint jacketed I would like to use along with n133 as I have 16#.
After seating bullet, there is 1.03 inches left for powder in the case. I filled the case to where the bullet would not compress the powder and then weighed and came up with a 100 percent fill non compressed as 15.9 grains .
11 grains of n133 would give a 69% 10 grains is 56% fill of remaining case after seating.
Anyone got quickload and help me out here?
Trying to make sure i don't get into pressure issues or secondary explosion. Rule of thumb for fast powders would be never go below 30% fill. certainly nowhere near that just looking for some advice I'm a mac user and have no way to use quickload.
can someone run this for me please?
