Does any one have a G7 BC on these .277, 165r grainers? On the website the G1 is .650.
Told ya!
Does any one have a G7 BC on these .277, 165r grainers? On the website the G1 is .650.
Does any one have a G7 BC on these .277, 165r grainers? On the website the G1 is .650.
Half of that ... .325.
I'm doing well, I was asking about the 8 twist because it is available and the right taper. I am still up in the air about caliber but one of the two, elevation here is 1650ft but I usually hunt around 7000ft.
I used a 165 matrix in my 270WSM to put down a wounded elk in a cornfield....shooting through standing corn 30-40 yards. The only thing visible was his antlers and a lot of thick corn, I guessed at where his body was and got the job done. The matrix at that range and having gone through an unknown amount of obstacles managed to reach the spinal cord on the bull.
Does any one have a G7 BC on these .277, 165r grainers? On the website the G1 is .650.
I'm doing well, I was asking about the 8 twist because it is available and the right taper. I am still up in the air about caliber but one of the two, elevation here is 1650ft but I usually hunt around 7000ft.
I used a 165 matrix in my 270WSM to put down a wounded elk in a cornfield....shooting through standing corn 30-40 yards. The only thing visible was his antlers and a lot of thick corn, I guessed at where his body was and got the job done. The matrix at that range and having gone through an unknown amount of obstacles managed to reach the spinal cord on the bull.
I run a .318 G7 but that is dialed in out to 1890 yards with that one optic, you may need to tune it a little.
Ok thanks. I didn't realize thats how you get the G7 BC's.
I thought this was for the 175gn G1 .680 G7 .336 dunno but thought I had read that after they were first shot. The .720ish first reported was a little optimistic The 175's are no longer listed on the site and I have no experience shooting them to verify that. I'm sure if you email them they would give better answers than this though.Rhian,
I gathered from somewhere that 0.336 G7 was being used. That's what I've plugged in. Well, see what it works out to be out of my motley rig....