Lead Free Bullets for the 6.5 Creedmoor

Greg Duerr

Well-Known Member
Joined
Mar 25, 2011
Messages
1,101
Location
Reno, Nevada
Will be hunting in a lead free state this fall and will be shooting my 6.5 CM What bullet works for you and what powder. I have H4350 that I use with the 140 Berger and I use Lapua Cases, and a custom 700 with a 26" Benchmark 1.8 barrel

Barnes 127gr LRX, Nosler 120gr E-Tip or Hornady 120Gr GMX
Give me an idea of your load, velocity and COAL, seating deapth

Thanks for your help
 
I'm shooting the 124 Hammers in my savage model 11 260. Two possible loads right now with superformance one just under 3000 and another around 3075. I was shooting the Barnes 127 LRX before but couldn't get to 2900 fps and bullet consistency was not that great. Shot good under 3-400 but groups opened up a little after that. So far hammers are approaching 0.5 Moa with low teens ES. Barnes I shot a .3 Group but everything else was just under 1 Moa.
 
124g Hammer Hunter with varget at just over 3000fps. Shot .5moa in Ruger with Vortex genII.

Steve
You prefer Varget over H4350 for this bullet in a 260 Remington? What starting loads would you recommend with the 124 Hammer in the 260.??
 
You prefer Varget over H4350 for this bullet in a 260 Remington? What starting loads would you recommend with the 124 Hammer in the 260.??
Not necessarily. The thread title was for creedmore. That is what we loaded in a creedmore.

Steve
 
Cutting Edge Bullets 130GR. MTH With 42Gr. RL-17 seated .669 to the seal tight band. Shoots inside 1/2" groups at 200 Yards and is DRT on Deer and Hogs. I have 2 different rifles and the accuracy is nearly identical. Speed from my 28" bbl rifle is just under 3,050 FPS. I am stuck in California and have tried nearly all the lead free bullets in the last 5 years but the CE MTH and CE Raptors are the best I have found for DRT results. Nearly all their energy is expended inside the animal rather than blowing straight through.
 
Warning! This thread is more than 6 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top