LE Wilson chamfer tool?

[Troutslayer2]

If you use this component of the Wilson case trimmer, do you pull out the cutter and insert the chamfer all in one go? Or do you do that as a different step? I was thinking of getting one but I use the cutter with the drill attached and wondering how much hassle it is to switch between the cutter and the chamfer back and forth. Is the chamfer tool worth getting?

 

[Seabeeken]

Its easy to change them but I did it as a separate step. Since I still had to deburr the outside of the neck, I decided to just go back to my hand tool.

 

[QuietTexan]

Since I still had to deburr the outside of the neck, I decided to just go back to my hand tool.

X2. Until/unless they offer a 3-way I don't use the chamfer tool in my Wilson anymore, only does half the job. I still trim with the tool, but it's a rare task for me so I'm not spending money on a Giraud.

 

[Seabeeken]

X2. Until/unless they offer a 3-way I don't use the chamfer tool in my Wilson anymore, only does half the job. I still trim with the tool, but it's a rare task for me so I'm not spending money on a Giraud.

Sold my wilson. Those case holders add up with all the different cartridges i use