Krazy kloth kuestion

[cohunt]

I thought the title would be "kute" then i realized it was 3 K's -‐oops

So I just picked up a piece of krazy kloth to see how it works to "kleen kases"

It definitely has wax in it that stays on the brass after you wipe them with the cloth

Anybody that uses krazy kloth --- do you wipe the cases off with a microfiber towel after you "kleen the kases with krazy kloth"?

 

[Korhil78]

I tried it…I use 0000 steel wool Normally to clean my cases with a power tool and a shell holder in it. I was wanting to use the krazy cloth to avoid having to wipe the brass after cleaning with the steel wool. Turns out, you still have to clean the brass off and the power tool spinning the case will tear a hole in the cloth. I just went back to steel wool.

 

[Alibiiv]

I tried it…I use 0000 steel wool Normally to clean my cases with a power tool and a shell holder in it. I was wanting to use the krazy cloth to avoid having to wipe the brass after cleaning with the steel wool. Turns out, you still have to clean the brass off and the power tool spinning the case will tear a hole in the cloth. I just went back to steel wool.

If by my brass is "super" dirty on the necks and tumbling doesn't get the neck clean I use a product called NeverDull. This stuff works great on any metal surface. I chuck the brass up in my drill press, spin the case and apply the cloth to the brass and then microfiber after while it's still in the chuck. I can only do 1/2 the case at a time though. What is the tool that you are using with the shell holder? If I had something that holds the case by the base I could get the entire case at one time.

 

[Brathany]

One should wipe any wax or lube off of cases before chambering.

 

[slick Nick]

I have finally started using the wet tumbler, and wont go back I have had some of the best results and after rinsing well they look like new. JMO

 

[338 dude]

If by my brass is "super" dirty on the necks and tumbling doesn't get the neck clean I use a product called NeverDull. This stuff works great on any metal surface. I chuck the brass up in my drill press, spin the case and apply the cloth to the brass and then microfiber after while it's still in the chuck. I can only do 1/2 the case at a time though. What is the tool that you are using with the shell holder? If I had something that holds the case by the base I could get the entire case at one time.

Lee case holder for their case length trimmer mandrel