Hornady 243 Win 100gr Load Data

[Stammster]

Can someone send me a photo from the Hornady book with load data for 243 Win 100gr?

I'm trying to work up a mild load for a friend's kid using 100gr Interlocks.

I've already got references from Hodgdon and Nosler, and things are all over the place. Also I can't even get close to reconciling it with Quick Load.

Also any suggestions for a 2550-2600 fps MV would be helpful. I know I can get there with H4895 with some work up, but I've only got less than a pound left and I'm using that lot for my son's 270 and 30-30 loads.

I'm hoping I can get to that MV range with H4350 or IMR-4064, as I have a ton of those powders - but don't want to be below the minimum recommended charge weight.

 

[jrock]

My book shows low end values as
IMR 4064 = 31g @ 2600 fps.
H4350 = 37.4g @ 2700 fps.

It doesn't list any of the other powders on your list.

 

[badthirtyone]

IMR 4064 is wonderful in the 243 in that weight range of bullet. I would think it is one of the most highly regarded powders for that application. Should be able to load a ton of options that will get you at or close to the MV and recoil that you are looking for.

 

[JMW67]

I also believe 4064 is going to be the powder of choice to do what you are talking about

 

[F-270]

My book agrees with jrock's numbers but does show 29.4gr of IMR4064 @ 2500fps before 31.0gr @ 2600fps.

 

[jeremy.b]

It's an older edition but here ya go:

 

[Stewart2550]

This is from the 11th edition.

 

[DoneNOut]

I'm loading 105gr Amax and 100gr BTSP with H100V, RL-17 and getting 3000+fps. around the 42gr mark with Win cases.

 

[Stewart2550]

I'm loading 105gr Amax and 100gr BTSP with H100V, RL-17 and getting 3000+fps. around the 42gr mark with Win cases.

What twist?

 

[Stammster]

Thanks guys. I think I've got what I'm looking for. Much appreciated.

BFD...feel free to continue the hijack of this thread.

 

[Stewart2550]

Thanks guys. I think I've got what I'm looking for. Much appreciated.

BFD and Stewart...feel free to continue the the hijack if this thread.

Well I was more so curious on what twist you were running but apparently I clicked reply on his, my bad.

 

[Stammster]

Ok. I'm presuming it's a 1:10, like 95% of 243's. Could be even more twist than that. I'm going to get the gun from him this weekend.

 

[Stewart2550]

Good luck, hope the data helps out.

 

[DoneNOut]

What twist?

1/9.25" Remington barrel