Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Dialing in bore for threading and chamber?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jrock" data-source="post: 1370830" data-attributes="member: 78569"><p>I've used a setup similar to the Vipers jig and used copper rod for the bearing surface. I do get about .0005" of runout after I run my rough tenon and chamber prebore. I'll try switching to aluminum to see how it fares as a harder material yet softer than steel.</p></blockquote><p></p>
[QUOTE="jrock, post: 1370830, member: 78569"] I've used a setup similar to the Vipers jig and used copper rod for the bearing surface. I do get about .0005" of runout after I run my rough tenon and chamber prebore. I'll try switching to aluminum to see how it fares as a harder material yet softer than steel. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Dialing in bore for threading and chamber?
Top