Basher42
Well-Known Member
*SOLD!*
This is a custom Remington 700 long action chambered in .25-06. The barrel is a 25" 1:9 Shilen Select Match that is threaded 5/8x24 and has "Flatline" fluting in a #7 contour. The bolt was also diamond fluted, the bolt handle skeletonized, and an aftermarket bolt knob installed. The barreled action was then Cerakoted in graphite black, and a Timney 510 trigger was installed.
The McMillan A5 has the specs outlined in the attached photo, namely it being Sniper Fill, inletted for Badger M5 DBM, front bipod stud, four flush cups (two bottom, two left side), adjustable LOP system (spacers included) with a 1/2" Decelerator recoil pad, installed pillars, and a McCann SIRS mount inletted and installed for NV use. Colors are molded in 34% Medium Tan, 33% Dark Tan, and 33% Olive. Current bottom metal is a Hawkins Oberndorf M5 BDL, which holds 5rnds.
This rifle is a tack driver. With the 1:9 twist, you can shoot almost any .257 projectile out there. Berger's Stability Calculator shows the new-ish 131gr Ace from BlackJack as being marginally stable, but higher DAs would help quite a but there. If you plan to shoot a lot at higher altitudes, it would likely be fine. The Hornady 110gr ELD-X shot very well (3/8MOA) for the box I put through it.
Total build cost for this according to a prior owner was just north of $3100 not including the cost of the action or recoil lug. Round count is just under 250 after the box I put through it. Recoil is relatively light, and the .25-06 is supposed to hit pretty hard for how little it recoils. This would make a fantastic all-around use rifle, although it may be a bit heavy for mountain hunts.
*The bipod, stock pack, and QD sling swivels shown are not included!*
I'm asking $1750 shipped for this gorgeous rifle, or partial trade from the list below. Any questions, just ask!
*TRADES (plus cash where needed):*
-Used Vudoo V22 .22LR (20" MTU or Kukri in black highly preferred)
-CZ 457 MTR or VPT in .22LR
-CZ 452FS or 455FS
-CZ 452 Ultra Lux (might consider a good looking Trainer)
-KRG Bravo (R700 SA, black or FDE)
-FGMM or Prime .308WIN 175gr OTM ammo
-Hornady Match .308WIN 168gr EDL-M ammo
-Hornady Match 6.5CM 140gr ELD-M ammo
-Berger 6.5CM 140gr Hybrid ammo
-Wolf Match Target or Match Extra .22LR
-SK Standard+, Rifle Match, or Long Range .22LR
-Lapua Center-X .22LR
-Eley Tenex .22LR
-Other high-quality, mid-grade .22 match ammo
-Hornady .308 168gr ELD-M projectiles
-Redding Type S FL .308WIN die set (P/N: 36155)
-Vortex Viper PST2 5-25x50 EBR-7C
-Vortex Razor Gen2 4.5-27x56 EBR-7C
-AICS .308 10rnd mags
-FN TBM .308 10rnd mags
-Bergara B14R mags
-Glock 43, 19X, 45, or 17
-Ruger LCR .38SPL
-FGMM .38SPL 148gr LWC ammo
-Area419 Hellfire brake in 6.5mm or .30cal
-Insite Arms Heathen brake in 6.5mm or .30cal
-APA Lil Bastard brake 6.5mm or .30cal
-Vortex Razor UH-1
-Timney Calvin Elite 2-stage curved for R700
-Geissele Super700 2-stage trigger
-Quality short action 20-30MOA scope base
This is a custom Remington 700 long action chambered in .25-06. The barrel is a 25" 1:9 Shilen Select Match that is threaded 5/8x24 and has "Flatline" fluting in a #7 contour. The bolt was also diamond fluted, the bolt handle skeletonized, and an aftermarket bolt knob installed. The barreled action was then Cerakoted in graphite black, and a Timney 510 trigger was installed.
The McMillan A5 has the specs outlined in the attached photo, namely it being Sniper Fill, inletted for Badger M5 DBM, front bipod stud, four flush cups (two bottom, two left side), adjustable LOP system (spacers included) with a 1/2" Decelerator recoil pad, installed pillars, and a McCann SIRS mount inletted and installed for NV use. Colors are molded in 34% Medium Tan, 33% Dark Tan, and 33% Olive. Current bottom metal is a Hawkins Oberndorf M5 BDL, which holds 5rnds.
This rifle is a tack driver. With the 1:9 twist, you can shoot almost any .257 projectile out there. Berger's Stability Calculator shows the new-ish 131gr Ace from BlackJack as being marginally stable, but higher DAs would help quite a but there. If you plan to shoot a lot at higher altitudes, it would likely be fine. The Hornady 110gr ELD-X shot very well (3/8MOA) for the box I put through it.
Total build cost for this according to a prior owner was just north of $3100 not including the cost of the action or recoil lug. Round count is just under 250 after the box I put through it. Recoil is relatively light, and the .25-06 is supposed to hit pretty hard for how little it recoils. This would make a fantastic all-around use rifle, although it may be a bit heavy for mountain hunts.
*The bipod, stock pack, and QD sling swivels shown are not included!*
I'm asking $1750 shipped for this gorgeous rifle, or partial trade from the list below. Any questions, just ask!
*TRADES (plus cash where needed):*
-Used Vudoo V22 .22LR (20" MTU or Kukri in black highly preferred)
-CZ 457 MTR or VPT in .22LR
-CZ 452FS or 455FS
-CZ 452 Ultra Lux (might consider a good looking Trainer)
-KRG Bravo (R700 SA, black or FDE)
-FGMM or Prime .308WIN 175gr OTM ammo
-Hornady Match .308WIN 168gr EDL-M ammo
-Hornady Match 6.5CM 140gr ELD-M ammo
-Berger 6.5CM 140gr Hybrid ammo
-Wolf Match Target or Match Extra .22LR
-SK Standard+, Rifle Match, or Long Range .22LR
-Lapua Center-X .22LR
-Eley Tenex .22LR
-Other high-quality, mid-grade .22 match ammo
-Hornady .308 168gr ELD-M projectiles
-Redding Type S FL .308WIN die set (P/N: 36155)
-Vortex Viper PST2 5-25x50 EBR-7C
-Vortex Razor Gen2 4.5-27x56 EBR-7C
-AICS .308 10rnd mags
-FN TBM .308 10rnd mags
-Bergara B14R mags
-Glock 43, 19X, 45, or 17
-Ruger LCR .38SPL
-FGMM .38SPL 148gr LWC ammo
-Area419 Hellfire brake in 6.5mm or .30cal
-Insite Arms Heathen brake in 6.5mm or .30cal
-APA Lil Bastard brake 6.5mm or .30cal
-Vortex Razor UH-1
-Timney Calvin Elite 2-stage curved for R700
-Geissele Super700 2-stage trigger
-Quality short action 20-30MOA scope base
Last edited:
