christensen Dual Ejector removal help

[Ohlson7mm]

needing to remove my Dual Ejectors on the bolt of my new ridgeline in 300win mag, im pretty sure i just push them in little then knock out the roll pin "assuming the one pin hold's both"
just wondering if any ones actually taken theirs out ,tips ,ect
new to the rem700/clone type action/bolt
and not a gunsmith just a handloader
thanks for any feedback

 

[cahunter805]

Do your work with the bolt inside a ziploc bag in case the spring/ejector go flying when you drive the pin out.

 

[MagnumManiac]

I just hold a finger over the ejectors as I tap the pin out, it's not under huge spring tension.
It looks to be a single pin.
I don't run an ejector in my comp guns.

Cheers.

 

[Ohlson7mm]

Thanks, thats what i figured never seen a dual setup before

 

[Roninco]

I find this helps with two lug bolts:

SINCLAIR INTERNATIONAL SINCLAIR REMINGTON EJECTOR SPRING TOOL | Brownells

This tool is designed to compress and control the ejector on Remington style bolts. The tool compresses the ejector and then turns to engage the locking lugs to hold the ejector in a compressed position. This allows you to drive the pin out and re...

www.brownells.com

 

[Ohlson7mm]

I find this helps with two lug bolts:

SINCLAIR INTERNATIONAL SINCLAIR REMINGTON EJECTOR SPRING TOOL | Brownells

This tool is designed to compress and control the ejector on Remington style bolts. The tool compresses the ejector and then turns to engage the locking lugs to hold the ejector in a compressed position. This allows you to drive the pin out and re...

www.brownells.com

This is perfect thank you