Anyone use a LAW stock??

[Wilderness Blacktail]

I have a Weatherby Vanguard that I'd like to restock. It currently has a B&C Medalist stock that is great but bulky feeling and I'd like to get one that is slimmer in my hand, specifically the action area.
Anyone have one to take some measurements on? How does it feel to you?

 

[MagMan]

They are what was left of High Tech Specialties. Nice stocks though they take quite a bit of work to finish properly. Mark Bansner is doing stocks again but I'm not sure if he offers a Weatherby inlet. I can get you measurements from an Extreme Sheep Hunter tomorrow but that is the only one I have experience with. They are as slim as they get.

 

[Wilderness Blacktail]

Thanks! And I was aware of the lineage to Mark in general but have no real world data to go with it. I appreciate it.
They advertise the Howa 1500 which is the same rifle as WBY Vanguard so it should be good there.

 

[Wilderness Blacktail]

I just emailed Mark to see if they can fit one to this action. Thatd be sweet!

 

[LongBomber]

What measurements would you like? I have a short action LAW rifle, can grab some measurements off it.

I like it much better than the b&c sporter stocks, they have that awkward thick wrist. But it still is fairly wide along the bottom metal.

 

[Wilderness Blacktail]

Thanks LongBomber!

Just the width at the middle of the action and about an inch up the barrel. Where its carried basically.

Yeah the B&C stock is too clunky for me, the short thick wrist area is definitely noticeable.

 

[LongBomber]

Sorry took me a day, darned working for a living..

In front of the trigger guard is 1.84"
Front action screw 1.75"

The bottom is rounded right where the bottom metal sits, but is a bit more squared off infront of that. Hopefully it shows in the picture

 

[Wilderness Blacktail]

Thanks! That helps a bunch.