Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Adjusting Die to Chamber?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Autorotate19" data-source="post: 379521" data-attributes="member: 20956"><p>Well I tried what ridge runner said, expanded the neck to .30 call then sized it down until bolt would close with resistance. Tuned in just a touch more and they chamber fine. Is it okay if the bolt is just a little tight, or should it be normal? Thanks for all the help guys! O and I was searching around, and a few guys were talking about using a paper clip to measure the stretch in front of the belt. Does anyone do this. Thanks</p></blockquote><p></p>
[QUOTE="Autorotate19, post: 379521, member: 20956"] Well I tried what ridge runner said, expanded the neck to .30 call then sized it down until bolt would close with resistance. Tuned in just a touch more and they chamber fine. Is it okay if the bolt is just a little tight, or should it be normal? Thanks for all the help guys! O and I was searching around, and a few guys were talking about using a paper clip to measure the stretch in front of the belt. Does anyone do this. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Adjusting Die to Chamber?
Top