Nevrsummr
Well-Known Member
What size neck bushing yall using for adg brass?
7 PRC bushing size
- Thread starter Nevrsummr
- Start date
Help Support Long Range Hunting Forum
Short anwswer: Most use about .002" less than the neck diameter of a loaded round.
You might be around. 310 or .311
Measure O.D. of loaded Bullet neck..
With the brass you are using and bullet.
Subtract. .003 - .004
that will be bushing size.
I seated the bullet I am using. Measured.
Pulled the bullet.
Hope this helps.
Measure O.D. of loaded Bullet neck..
With the brass you are using and bullet.
Subtract. .003 - .004
that will be bushing size.
I seated the bullet I am using. Measured.
Pulled the bullet.
Hope this helps.
Nevrsummr
Well-Known Member
Okanogan
Well-Known Member
I'm using .311 for both ADG and Peterson.
