Reamer has cut one chamber by my gunsmith. It was setup as a "max effort" 338 Lapua as far as throating with the 300 gr Berger. Boat tail junction is right at or slightly above the neck/shoulder junction.
The neck is no turn for most brass, a bit tight on Lapua brass. You may need a skim cut. ( I did not with Lapua or Peterson Brass). I can give some load data to buyer. Rifle shoots excellent but one 338 Lapua barrel is enough for me. My ELR days are over and I'm moving back to smaller stuff.
338 Lapua Mag PTG bushing pilot
0.3708 neck
0.256 freebore
43841 drawing
Manson go gauge
$170 shipped for set.
one bushing included
The neck is no turn for most brass, a bit tight on Lapua brass. You may need a skim cut. ( I did not with Lapua or Peterson Brass). I can give some load data to buyer. Rifle shoots excellent but one 338 Lapua barrel is enough for me. My ELR days are over and I'm moving back to smaller stuff.
338 Lapua Mag PTG bushing pilot
0.3708 neck
0.256 freebore
43841 drawing
Manson go gauge
$170 shipped for set.
one bushing included
