Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
30 cal Minimum bearing surface in case neck?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="misterc01" data-source="post: 1641818" data-attributes="member: 109160"><p>Here is another one.</p><p>"Set your <strong>seating</strong> die to <strong>seat</strong> at a <strong>depth</strong> between .015 and .03 inches less than your rifle <strong>seating depth</strong>. B. Lightweight <strong>bullets</strong> may need to be <strong>seated</strong> further from the rifling. A <strong>depth</strong> of one <strong>bullet</strong> diameter inside the case neck gives good alignment and neck tension for ignition" The subject goes all over the place, but the bottom line I took from it to seat it enough seat it so the bullet is and stays concentric and does not "tip" before reaching the lands. I try not to seat so deep that I end up compressing the powder and inadvertently get an over pressure situation.</p></blockquote><p></p>
[QUOTE="misterc01, post: 1641818, member: 109160"] Here is another one. "Set your [B]seating[/B] die to [B]seat[/B] at a [B]depth[/B] between .015 and .03 inches less than your rifle [B]seating depth[/B]. B. Lightweight [B]bullets[/B] may need to be [B]seated[/B] further from the rifling. A [B]depth[/B] of one [B]bullet[/B] diameter inside the case neck gives good alignment and neck tension for ignition" The subject goes all over the place, but the bottom line I took from it to seat it enough seat it so the bullet is and stays concentric and does not "tip" before reaching the lands. I try not to seat so deep that I end up compressing the powder and inadvertently get an over pressure situation. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
30 cal Minimum bearing surface in case neck?
Top