fseaman
Well-Known Member
Based on my knowledge of metallurgy, machining and gunsmithing (amateur).
I would advise against this.
There is also the wet rag/towel idea but same.
Barrel cooling - I am trying something new
- Thread starter Mrvmax
- Start date
Help Support Long Range Hunting Forum
I would advise against this.
There is also the wet rag/towel idea but same.
We're talking about cooling from something like 190F to ambient, and not that rapidly either. What metallurgical concerns do you have?
TonyRumore
Well-Known Member
Years ago, I attended a Soviet Weapons Armorer's course at Front Site in Arizona. We fired the PKM machine gun until the barrel was nearly glowing, and then the instructor removed the barrel from the gun and dunked it into a 55 gallon drum of water. This occurred many times over the course of a day and did not seem to have any negative effect on the machine gun's operation or accuracy. I think there are some situations where rapid water cooling may not be an issue.
Tony
fseaman
Well-Known Member
I have been trolled so much that this kind of reply question makes me warry.
fseaman
Well-Known Member
It's "designed " for that. It's a machine gun not a rifle you are trying to hit an Elk with at +500 yards.
Apples and oranges.
akmtnhnt
Well-Known Member
Yes, because soviet machine gun accuracy is world renown. It might not be possible for it to get worse, so sure.
Not trolling. I have no applicable expertise myself.
Bob Wright
Well-Known Member
"Misting" a gun barrel won't touch the metallurgy. A real hot barrel in target shooting is one you just can't hang onto bare handed. The last heat treat was probably at 900-1000°F to normalize as raw bar stock before gun drilling and finishing.
Squirting water on that finished, hot to touch barrel, is nothing.
Squirting water on that finished, hot to touch barrel, is nothing.
K9TXS
Well-Known Member
Yes you can with no effect to the barrel. When PD hunting, I use a fiber towel draped over the barrel. I put the towel on wet. As shooting continues, the towel is checked periodically to make sure it is at least damp. If not a spray bottle is used to wet it down again. Many shooters use this in the PD & ground squirrel fields.
fseaman
Well-Known Member
Well, several have replied to the "metallurgy" that they do it without problems and I don't want to be trolled.
