Fired brass. Using CCI 250 primers. Only got a heavy bolt lift with 60gn of 4831sc. Other than that load, the only pressure sign I got was the ejector mark. No flat primers or cratering.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Alternative powder to Re23 for 280ai
- Thread starter Tandin93
- Start date
Help Support Long Range Hunting Forum
My biggest issue has been case capacity with RL23 and long mono's. H4831sc and H4350 fix this issue. I may lose 50 fps, but I can accept that. Your rifle is the only thing that will tell you what will work best. Mine gets the best results with H4831sc when shooting 160 grain pills. H4350 is my go to for 140's.
I would try standard primers if you have them. Really no need to run magnums. See if the ejector marks go away. Could you also have a stiff ejector giving you false pressure signs?
I'll definitely try the standards. I really think it's possibly a stiff ejector. I took it out to check and see if it had a burr, or sharp edges yesterday, and it was extremely stiff compared to some other rifles. Idk. I cleaned up all of my brass and I'm going to load some more today. I ran and picked up some more Accubond 160s yesterday. My rifle really seems to like those a lot. How would I know if it is just a stiff ejector? Because it really is the only pressure sign that I have. I'll try to get some pics of the brass and upload them.
I ran into the same problem with longer monos's. Although the best load I have found in my rifle is probably 143 hammer hunters over RL 23.
I had my GS look at my ejector on my Rem 700 cause I was getting some ejector marks at mid weight charges and he said I had a stiff ejector. He said some 700's were like that. A sign of a stiff ejector, at least on 700's is that it will leave a scratch on the brass, when you are pulling the bolt back.
Josh06
Well-Known Member
I'm using Peterson brass also with GM215M. I was thinking you would probably get 3k using Ramshot Hunter. 4831sc is really slow in my barrel.
I'll give that a shot. Here is my brass from today. 58.2gn of 4831sc under AB 160's
Just under 1 moa
Avg-2851
ES-24.3
SD-8.9
Attachments
Nice! I really like the 143HH.
Attachments
Question.. what is your COAL measurement?I realize this is very rifle specific, but I'd like to get some reference. The reason I'm asking this is, after doing some research it seems as if pressure could be increased by seating too close to the lands. I have been seating about .010 off the lands, and I'm wondering if by seating deeper, I can reduce pressure with the same powder charge.
Edit.
After diving down the YouTube rabbit hole, I found this video. It seems to support my theory. Has anyone experienced this?
Last edited:
Josh06
Well-Known Member
I'm at 0.050 off the lands in my gun which is 3.351 coal or 2.670 bto using the hornady #28 comparator.
Well, I guess you learn something new every day. I decided to seat some bullets .080 off the lands with the same exact powder charge and what do you know, zero pressure signs and my groups tightened up considerably… I didn't realize seating depth affected pressure that much.
The flier was my cold bore shot. The other is a 5 shot group at .648"
Average fps is 2860
The flier was my cold bore shot. The other is a 5 shot group at .648"
Average fps is 2860
