Justice1327
Well-Known Member
PM Sent
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Labeling a gun barrel
- Thread starter willtim
- Start date
Help Support Long Range Hunting Forum
I live 15 minutes from Snowy Mountain Rifles, they did mine for $40
waveslayer
Well-Known Member
Note in your phone, laminate a Note that sucks with is log book?
The barrel/caliber being labeled isn't part of any ATF requirements. The only thing required for labeling is the actual serialized component, which if a bolt gun would be the receiver. It sounds like he's just wanting to mark the barrels to be able to differentiate between them? I would think two different barrels from two different makers should be easy enough to distinguish one from the other, especially since one is cerakoted?
Agreed! I keep all the invoices for all my custom-made components, including the barrels. I also have a tracking log of what components went to all my rifle builds, including the serial numbers of actions, scopes, etc. All my rifle chamberings are engraved on the barrel (i.e., .257 WBY, .264 WM, .270 AI, .30 Gibbs, .30 Lara, 338 Thor, etc.), and I can always refer to my tracking log for other pertinent information, along with the load development information.
PopNFresh
Well-Known Member
as a manufacturer or importer there are required markings per atf for firearms.
The gray area hits when a gunsmith is not a manufacturer but is replacing parts (like spinning a new barrel up) he's not technically a manufacturer so are the markings required. putting a client's parts on a client's gun makes things a little different than buying a pre-made firearm. Ive done enough atf audits to know your logbook can pretty much have none available/listed on any section if the info isn't there in the firearm. hell, NSN is acceptable to put in for no serial number.
regulations.atf.gov
The gray area hits when a gunsmith is not a manufacturer but is replacing parts (like spinning a new barrel up) he's not technically a manufacturer so are the markings required. putting a client's parts on a client's gun makes things a little different than buying a pre-made firearm. Ive done enough atf audits to know your logbook can pretty much have none available/listed on any section if the info isn't there in the firearm. hell, NSN is acceptable to put in for no serial number.
27 CFR § 478.92 | eRegulations
K9TXS
Well-Known Member
There are two good systems, stamping & etching.
The etching method you don't have to remove the scope or action from the stock if you know what your doing. Mine are etched.
The etching method you don't have to remove the scope or action from the stock if you know what your doing. Mine are etched.
PopNFresh
Well-Known Member
I didn't think etching reached the required depth to be considered a legal marking
slv hunter
Well-Known Member
Duct tape and sharpie lol
Taj
Well-Known Member
I found myself very reluctant to beat on a $ 500 barrel job with a punch and hammer, so I bought a commercial 80 watt fiber laser for the shop. I now do caliber markings for several smiths that do a lot of rebarrel work and have contracts with a manufacturer of medical products to do part and serial numbers on stainless and brass parts they manufacture. I'm also doing a bit of Form 1 NFA stuff for locals. The laser does an extremely clean job. I will never beat on another gun with a hammer and number stamps. IT sort of turned into a "monster".
Justice1327
Well-Known Member
???
HRM Johnny
Well-Known Member
I had the same reaction. ???
