Spotting scope monopod
- Thread starter emp1953
- Start date
Help Support Long Range Hunting Forum
med358-boise
Well-Known Member
**** this is perfect!Buy a spotting scope car window mount and large heavy duty wood clamp. Clamp the window mount to the tail of the wood clamp.
yobuck
Well-Known Member
If you remove the stem which supports the head on your tripod, could you then attach the stem to the wood rail by using U bolts with wing nuts?
These are an outfitters stands so I can't permanently make any changes. Med358's solution will work just fine and transport in a backpack easily.
med358-boise
Well-Known Member
Yo Buck,
I am not sure exactly what your asking but I would say two things:
1) The window mount head pivots around so any stout piece of flat steel (like the bar on that wood clamp) or other material that you can have protuding above the rail will work. The flat bar can be attached in many ways
2) Almost all spotting scopes and camera equipmemt use a 1/4 by 20 tpi thread bolt for mounting, there are numerous rotary ball swivels with a 1/4 by 20 tpi stud available on Amazon so options are endless as to how you mount them to the shooting rail.
I am not sure exactly what your asking but I would say two things:
1) The window mount head pivots around so any stout piece of flat steel (like the bar on that wood clamp) or other material that you can have protuding above the rail will work. The flat bar can be attached in many ways
2) Almost all spotting scopes and camera equipmemt use a 1/4 by 20 tpi thread bolt for mounting, there are numerous rotary ball swivels with a 1/4 by 20 tpi stud available on Amazon so options are endless as to how you mount them to the shooting rail.
Last edited:
Thanks again for the simple solution. My eyes are not up to counting points so good now-a-days, so I'm needing a little help.
yobuck
Well-Known Member
Im not asking anything, i was simply replying to the question.
But the window mount idea should work, but so would the tripod stem with a clamp as well.
Some window mounts would probably open wide enough that a clamp wouldnt be necessary.
There are always lots of them for sale on Ebay.
med358-boise
Well-Known Member
When you look at the wood clamps get one that the flat steel bar is stout enough to support the weight of the spotting scope. The bar migh be longer than you want but just cut it to appropriate lenght.
I have made a couple of these and one of the window clamps had a small nipple in the center of the clamp so I drilled a hole in the center of the flat steel bar to make a recess for the nipple.
340 in Va
Well-Known Member
Simple fix, and easy to move to any place in the blind.
Recent Posts
-
-
-
-
7mm STW Brotherhood - For those who shoot the 7mm Shooting Times Westerner
- Latest: Victor3Ranger1
-
