• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Thread cutting

Any chance of taking an evening machining class at your local community college? I got hands-on, practical training by taking one, and I still hate single-pointing threads, but that's just me.
 




Here are two trial threading videos to pursue. None will be a substitute for hands on learning. You just have to get on the machine and set it up to cut threads. No it's not simple, it's a machining process which requires those threads to fit other threads.

Study and practice. I've cut 10's of thousands of threads in most materials and lots of different placements. All it takes is practice and experience. Start simple, inexpensive steel, quality cutting tools. You'll learn a lot from your first crash!:eek::cool:

Enjoy the learning experience!
 
There are lots of good books on single point thread cutting out there plus the number of You Tube video's are almost infinite. Be careful on some of the videos, some folks have some "wacky" idea's on the subject. I have cut hundreds of SP threads doing rifle barrels---on both ends ( over 40 years worth) . That's not counting the airplane and car parts I've had to conjure up. It's not hard but does take a little experience and knowledge to do a good job. It's not rocket science and you will gain the experience very quickly but don't start your learning curve on a $400 barrel blank. Read up on it and make a few "junk" projects you can afford to screw up. You'll get it.
 
Tech college class.
Mentor.
YouTube.
Follow safe turning practices.
Practice. Consider using short chunks of cold rolled steel or even aluminum.
Run correct spindle speed.
Keep your work chucked up short (not more than 3x diameter) unless supported by tail stock.
Correct tooling, correct height and angle.
Tight machine (no slop on compound or cross feed).
 
Yea and as I learned, a perfect cut tenon to match the receiver was too tight. Threads were to sharp and I almost had to cut it off

Thanks

Buck
 

Similar threads

Clark
Cutting threads
2 3 4
Replies
42
Views
9K
spladi
S
A
Cutting down a fluted barrel --Muzzle thread Issue
Replies
5
Views
6K
AKdan
A
X
Cutting fluid
Replies
0
Views
974
XringCG
X
Gregg C
Cutting BAT reciever inlet
Replies
7
Views
734
Gregg C
Gregg C
F
Cutting savage extractor slot
Replies
0
Views
931
foreign
F

Recent Posts

Top