I am looking for someone to inlett a bell and carlson blind mag stock to receive ptg aics bottom metal. This will be for a savage with 4.2 action screw spacing. I am waiting on some possible stock options from another lrh member, but just in case they don't work out, I want to have some options. Thanks!
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Inletting needed
- Thread starter cgailey
- Start date
Help Support Long Range Hunting Forum
TC338
Well-Known Member
Contact LRI, Long Rifles Inc.
Did you check with B&C when you bought you stock?
I have not ordered it yet. Do they custom inlett?
huntinfool18
Well-Known Member
I talked to Lri last week and they told me 6 plus months on stock work. But that was a full inlet job. A small job like bottom metal might be shorter
Not sure if they do custom Inlet work. We purchased several B&C Stocks that we factory Inlet for what we had.
Unknown Munitions did a spectacular job on a Stocky's VG-2 with a M-5 inlet for their own DBM. Very precise.
taylorms
Well-Known Member
Do you have any local gunsmiths?
They make stocks that will take the PTG bottom metal. I have one on a LA. I did have to add some bedding compound to make it sit right though.
13 months…..
Bucklowery
Well-Known Member
Richard's custom inlet a blank for cdi bottom metal. I sent them a diagram and it was spot on. It was their blanks then I shaped it for a build
Thanks
Buck
Thanks
Buck
