• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

New to Mandrel use

topcat265

topcat265

Well-Known Member
LRH Supporter
Joined
Aug 3, 2024
Messages
51
Location
Naples, Fl
I just decided to start using mandrels in my reloading.
I called 21st century innovation and purchased their products.
In my conversation, they encouraged the use of their dry neck lube when using the mandrel, which I purchased.
Yesterday, I resized brass, using One Shot as the lubricant. I then used the mandrel. As the case mouths were already lubed, I did not feel the need to use the dry lube.
All seemed to go well, but I wanted to check here to see if I was making a mistake by relying on the residual one shot rather than the dry lube. I did purchase the black nitride mandrels, which are supposedly more slick.
Any thoughts?
Thanks,
T
 
I use graphite in the necks. Be careful that you don't load powder right after the one shot because it can cake the powder if it's not all dry, especially any that made it to the bottom of the case, ask me how I know 😭😭😭. Graphite also helps with seating the bullets especially with new brass 😊
 
For mandrel use I've always used imperial sizing wax. Granted I'm expanding up .020 so the wax helps a ton. And as said above, clean all lube (esp one shot) after sizing with it. I usually ultrasonic clean before depriming, then again after to get the lube off. It makes life a lot easier.
 
Same at the others, I use one shot for lube. I've been doing it for many years. The potential issue is ball powder etc can stick to the neck a little bit. Just a cottonswab in and out and done if needed. On larger kernel powder I've not had an issue. I have graphite powder too and don't use it anymore. I spray one shot at an angle to lube the inside and outside of the neck. I use imperial on the body of most cases. Works fine for me, I'm sure someone would say it's stupid...... LOL
 
I've lubed the case necks inside with Imperial wax using inexpensive Q-Tip-type swabs. I lube the outside with One shot rubbing the cases and letting them dry. It's worked for me but choose any method that gives you the results you're looking for.
 
topcat265 said:
I just decided to start using mandrels in my reloading.
I called 21st century innovation and purchased their products.
In my conversation, they encouraged the use of their dry neck lube when using the mandrel, which I purchased.
Yesterday, I resized brass, using One Shot as the lubricant. I then used the mandrel. As the case mouths were already lubed, I did not feel the need to use the dry lube.
All seemed to go well, but I wanted to check here to see if I was making a mistake by relying on the residual one shot rather than the dry lube. I did purchase the black nitride mandrels, which are supposedly more slick.
Any thoughts?
Thanks,
T
Click to expand...
My latest procedure is to spray/roll Frankford Arsenal lube being careful to shield the shoulder neck. I size without the expander ball. Then I use 21st Century Mandrel after dipping case mouth in dry graphite. It leaves some graphite residue during bullet seating.
 

Similar threads

tribb
Tell me about mandrels? Use of, pro & con
3 4 5
Replies
65
Views
6K
tribb
tribb
B
how to use
Replies
9
Views
2K
sp6x6
sp6x6
2
Action to use on new .270wby cal Custom Build
2
Replies
16
Views
4K
cummin_un_glued
C
Bulseyetom
Which daypack to use
Replies
9
Views
3K
Cruizin
C
T
Which Wind to use?
2
Replies
24
Views
4K
ss7mm
S

Recent Posts

Top