I posted about this problem before and still no luck finding the problem.
I'm having hard to very hard bolt lifts even though I'm starting out at the very bottom of the load data.
It's like I'm over pressure but with our the flattened primer.
Also there's a small gouge in the brass case like something is digging into it.
The only thing I'm seeing is where the cut out is for the claw extractor is not flush to the face. Does anybody know if this would cause problems with brass getting stuck?
I'm having hard to very hard bolt lifts even though I'm starting out at the very bottom of the load data.
It's like I'm over pressure but with our the flattened primer.
Also there's a small gouge in the brass case like something is digging into it.
The only thing I'm seeing is where the cut out is for the claw extractor is not flush to the face. Does anybody know if this would cause problems with brass getting stuck?
