Help new barrel problems

Rotten

Well-Known Member
Joined
Apr 25, 2024
Messages
285
Location
Utah
I posted about this problem before and still no luck finding the problem.
I'm having hard to very hard bolt lifts even though I'm starting out at the very bottom of the load data.
It's like I'm over pressure but with our the flattened primer.
Also there's a small gouge in the brass case like something is digging into it.
The only thing I'm seeing is where the cut out is for the claw extractor is not flush to the face. Does anybody know if this would cause problems with brass getting stuck?
 

Attachments

  • Screenshot_2024-09-10-05-33-34-70_92460851df6f172a4592fca41cc2d2e6.jpg
    Screenshot_2024-09-10-05-33-34-70_92460851df6f172a4592fca41cc2d2e6.jpg
    63.3 KB · Views: 60
  • Screenshot_2024-09-10-05-37-43-23_9fc854ef6bb5ff9c44487fd4502f259a.jpg
    Screenshot_2024-09-10-05-37-43-23_9fc854ef6bb5ff9c44487fd4502f259a.jpg
    50.7 KB · Views: 60
  • IMG20240910051639.jpg
    IMG20240910051639.jpg
    187 KB · Views: 62
  • Screenshot_2024-09-10-05-37-22-56_9fc854ef6bb5ff9c44487fd4502f259a.jpg
    Screenshot_2024-09-10-05-37-22-56_9fc854ef6bb5ff9c44487fd4502f259a.jpg
    108.1 KB · Views: 61
  • 1725966535454.jpg
    1725966535454.jpg
    112.2 KB · Views: 57
1725991992778.jpg
sorry it's not a very clear picture. These didn't stick to bad as I'm using .1 gr over starting load data.
It's a Kimber 8400 chambered in 270wsm. Barrel was done by pac-nor
I don't know if I want to deal with them again as this is the 2nd barrel I've had problems with on the same rifle.
 
Top