Just loaded my first Hammer....concerned.

floyd kittrell said:

I've loaded and shot Barnes for 40 plus years, they are nothing like the Hammer line, two totally different critters.

Click to expand...

MELEX said:

View attachment 600635I just loaded my first Hammer HHT, and I am concerned about the case mouth not being supported by the bullet as well as neck only making contact on two narrow rings of the bullet. Seems as though the rounds will be very sensitive to rough use, or recoil while I'm the gun.

Click to expand...

Varmint Hunter said:

Only 2 contact points is normal for a HHT bullet. If you try a HH bullet you will probably be able to get 3 points of contact. I generally prefer the HH for that reason. Factory FL dies likely give you plenty of neck tension (some say interference fit). Measure the neck diameter of a recently FL sized case, and then measure the same case with a bullet fully seated. The difference between the 2 measurements is what your "neck tension" is.

FWIW - most Hammer shooters seem to prefer some level of crimp. Personally, I'm not one of them but you can't ignore the opinion of the majority.

Click to expand...

MELEX said:

View attachment 600635I just loaded my first Hammer HHT, and I am concerned about the case mouth not being supported by the bullet as well as neck only making contact on two narrow rings of the bullet. Seems as though the rounds will be very sensitive to rough use, or recoil while I'm the gun.

Click to expand...

RockyMtnMT said:

FWIW I generally don't crimp. I might be in the minority too! LOL!

Click to expand...